top of page
METHOD OF PROTECTING AN EXPANSION JOINT
Cut off the strip with a knife of PiroCoat A painted mineral wool board with a width equal to the width of the expansion joint.
Steps 1 - 6
Place the previously cut strip in the expansion joint so that the top layer coated with PiroCoat A is
together with the partition
If the partition is thicker than 100 mm, then the space between the applied PiroCoat A painted mineral wool board strips should
be filled with any mineral wool.
If the protection must be made on both sides, place the cut PiroCoat A painted mineral wool board strip in the expansion joint on
the opposite side of the partition.
Joints between the PiroCoat A painted mineral wool board and the partition seal with PiroCoat A.
Properly protected expansion joint on one and both sides. In this way, you can protect horizontal and vertical expansion
joints both in walls and floor.
bottom of page